Sun Joe SWJ806E-HTG 2-in-1 Electric Convertible Pole Chain Saw | 8 inch · 8.0 Amp (Hunter Green)SWJ806E-HTG
- 2 tools in 1: pole chainsaw or chainsaw
- Ideal for cutting overhanging limbs and thin logs
- Telescoping pole extends to 8.6 ft.
- Powerful 7.5-amp motor cuts branches up to 7.5-inches thick
- 8-inch Oregon cutting bar and chain with automatic lubrication
- ETL approved; Full 2-year warranty
+ What type of oil does my unit take?
Your SWJ806E or SWJ806E-HTG uses regular Bar and Chain oil, available for purchase on our website under model number SWJ-OIL.
+ What bar does my unit use?
Your Saw Joe SWJ806E or SWJ806E-HTG uses an SWJ-8BAR 8-inch bar, available for purchase on our website.
+ How do I clean debris/residue from inside the unit?
Using the supplied flat-tip blade screwdriver, remove the end cover nut cap from the chain/sprocket end cover to expose the end cover nut.
Using the supplied hex key wrench, unscrew the end cover nut and remove the chain/sprocket end cover.
Remove any debris trapped under the end cover, around the sprocket, and between the chain links. If available, use compressed air to remove any fine debris from the mounting surface, bar, and chain.
If necessary, remove the cutting bar and chain from the mounting surface to clean any residue, then replace.
Replace the chain/sprocket end cover by inserting the rear tab of the end cover first into the rear tab slot on the mounting surface, and position the cover onto the saw head.
Tighten the end cover nut by hand. Remove all slack from the chain by turning the chain tension screw clockwise until the chain seats snugly against the bar with the drive links in the bar groove.
Tighten the end cover nut using the hex key wrench, then replace the end cover nut cap to secure the chain/sprocket end cover.
+ How do I make my chainsaw into a pole saw?
Converting your SWJ806E or SWJ806E-HTG from a chainsaw to a pole is as simple as pushing a button. Simply, pull the handle lock towards you. While pulling on the handle lock, use your other hand to grasp the front hand grip and slide the removable cutting head upwards to remove it. Connect the removable cutting head and the telescoping pole by aligning their ends together and sliding the removable cutting head downwards until it clicks into position. Finally, connect the removable handle and the telescoping pole by aligning the their ends together and sliding the removable handle upward until it clicks into position.
+ What chain does my unit use?
Your Saw Joe SWJ806E or SWJ806E-HTG uses an SWJ-8CHAIN 8-inch chain, available for purchase on our website.